Removal (Neon)

Fuel level sensor is mounted on fuel pump module. See Figure. Remove fuel pump module. See FUEL PUMP MODULE under FUEL SYSTEM. Depress retaining tab and disconnect electrical connector for fuel pump and fuel level sensor from electrical connector from bottom side of electrical connector mounted on top of fuel pump module.
Remove Blue locking wedge from inside of electrical connector for fuel pump and fuel level sensor. See Figure.
CAUTION: Note location of wires for fuel level sensor in electrical connector for fuel pump and fuel level sensor for installation reference. Wires must be installed in correct location.
Mark wire location in electrical connector for fuel pump and fuel level sensor for installation reference. Wires for fuel level sensor must be removed from the electrical connector for fuel pump and fuel level sensor.
Using small screwdriver, lift locking finger away from electrical terminal on the wire. Push wire with electrical terminal from electrical connector.
Using screwdriver, pry between fuel pump module and top of fuel level sensor to release fuel level sensor from fuel pump module. Slightly push fuel level sensor downward, toward bottom of fuel pump module.
Slide wires for fuel level sensor through opening on inside of fuel pump module. Slide fuel level sensor from channel on fuel pump module.