Using Scan Tool
- Turn ignition off. Connect scan tool to Data Link Connector (DLC), located under left side of instrument panel. See Figure. Turn ignition on. Access the "Read Fault" screen. Using scan tool manufacturer's instructions, read and record DTC (generic scan tool) or DTC message (DRBIII® scan tool), and freeze frame data.
- If scan tool will not power up, check for loose cable connections, bad cable or bad fuse.
- If scan tool displays a bus failure error message, this indicates a scan tool failure or a bus circuit failure. To diagnose and repair bus circuit failure, see appropriate BODY CONTROL MODULES article in ACCESSORIES & EQUIPMENT.
- If any DTCs are displayed, perform appropriate diagnostic test. See DIAGNOSTIC TROUBLE CODE DEFINITIONS . After repair is complete, clear DTCs from Powertrain Control Module (PCM) memory and perform appropriate verification test. Verification tests are located at the end of the diagnostic tests. If no DTCs are displayed, go to one of the following.
- For starting or driveability problems, go to INTERMITTENTS in appropriate TROUBLE SHOOTING - NO CODES article for diagnosis by symptom.
- For speed control problems and servicing information, refer to appropriate CRUISE CONTROL SYSTEMS article in ACCESSORIES & EQUIPMENT.
- For charging system problems, refer to appropriate GENERATORS & REGULATORS article in STARTING & CHARGING SYSTEMS.
- For transmission electronic controls system problems, refer to appropriate DIAGNOSIS article in AUTOMATIC TRANSMISSIONS.