Wiper Module: Removal
- Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
- Remove driver and passenger side wiper arms. Refer to WIPER ARMS
.
- Remove nine screws to cowl screen panel. Refer to COWL GRILLE AND SCREEN
.
- Remove wiper module mounting bolt located on top of the tower to tower beam.
- Remove eight bolts to Tower to Tower (crosscar) support (Fig 1
)..
Courtesy of DAIMLERCHRYSLER CORP.
- Remove three retaining bolts to windshield wiper module (Fig 2
).
Courtesy of DAIMLERCHRYSLER CORP.
- Lift wiper module away from vehicle body.
- Disconnect one wire connector.
- Remove windshield wiper module from vehicle.
- If replacing module, transfer wiper module grommets to new module assembly (Fig 3
).
Courtesy of DAIMLERCHRYSLER CORP.
- Remove one nut to crank arm and remove from motor (Figure
).
- Remove three retaining bolts from wiper motor (Figure
).
- Remove wiper motor from wiper module assembly. Install onto new wiper module assembly. Refer to WIPER MOTOR
.