Diagnostic Test

WARNING: This page is about a different car, the 2021 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR AN ACTIVE DTC
1. With the scan tool, record and erase RF Hub DTCs.
2. Try to turn the ignition on and off several times.
3. Wait one minute.
4. With the scan tool, read RF Hub DTCs.
  Is the DTC active?
  
  Yes
  - Go To 2
  No
  - Perform the THEFT AND SECURITY SYSTEM INTERMITTENT TEST. Refer to THEFT AND SECURITY SYSTEM INTERMITTENT TEST .
STEERING COLUMN LOCK MODULE NOT CONFIGURED
1. With the scan tool, erase the DTCs.
2. With the scan tool on the "Vehicle View", select: "Diagnostic Procedures".
3. Perform the "Restore Vehicle Configuration".
4. Wait one minute.
5. With the scan tool, select the Body Control Module.
6. Select "ECU Details".
7. Scroll to "ELV Present". It should read "Set".
8. Scroll to "ESCL System Present". It should also read "Set".
  Does the scan tool display the readings as listed above?
  
  Yes
  - The condition or conditions that originally set this DTC are not present at this time. Using the appropriate SYSTEM WIRING DIAGRAMS as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension and repair as necessary. If no problems are found, test complete.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Replace the Steering Column Lock Module in accordance with the service information. The Radio Frequency Hub (RF-Hub) must also be replaced along with the Steering Column Lock Module (ELV/ESCL). When replacing the RF-Hub and the Steering Column Lock Module (ELV/ESCL), the RF-Hub MUST be programmed BEFORE the Steering Column Lock Module (ELV/ESCL) is programmed.
  - Replace and program the Radio Frequency Hub (RF-Hub). Refer to MODULE, RADIO FREQUENCY (RF HUB), REMOVAL .
  - Replace and program the Steering Column Lock Module (ELV/ESCL). Refer to MODULE, SHAFT LOCK, REMOVAL .
  - Perform the RADIO FREQUENCY HUB VERIFICATION TEST. Refer to RADIO FREQUENCY HUB (RF HUB) VERIFICATION TEST .