Radio Frequency Hub (RF Hub) Module

REMOVAL 

1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
2. Partially remove the headliner to access the RF Hub located at the right front. Refer to HEADLINER, REMOVAL AND INSTALLATION .
3. Disconnect all of the wire harness connectors at the RF Hub.

   Courtesy of CHRYSLER GROUP, LLC

   1 - Fasteners

   2 - Wire Harness Connectors

   3 - RF Hub

4. If equipped, disconnect the remote start antenna connector.
5. Remove the fasteners and remove the RF Hub from the vehicle.

INSTALLATION 

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.

• Tighten the fasteners securely.