RF-Hub Programming

NOTE:

If other Electronic Control Modules (ECUs) need to be replaced with the RF-Hub before proceeding. Refer to MODULE REPLACEMENT AND PROGRAMMING ORDER GUIDE .

NOTE:

If, during programming, the diagnostic scan tool instructs to "Enter the vehicle PIN number," care should be taken because the RF-Hub will only allow 3 consecutive attempts to enter the correct PIN. If 3 consecutive incorrect PIN's are entered, the RF-Hub will Lock Out the scan tool. To exit Lock Mode, the ignition must remain in the Off position for 25 minutes. All accessories must be off. A battery charger connected to the battery during this time period is recommended.

NOTE:

The Powertrain Control Module (PCM) stores the secret key information. When the RF-Hub needs to be replaced, the secret key information will be retrieved from the PCM and then transferred to the new RF-Hub for security use.

This procedure is for Radio Frequency Hub (RF-Hub) equipped vehicles. If the vehicle is not equipped with a RF-Hub. Refer to MODULE, BODY CONTROL (BCM), MODULE PROGRAMMING .

NOTE: Obtain the vehicle PIN before starting the routine.

NOTE: Sitting in the vehicle with the doors closed is a requirement for this routine to complete properly.

NOTE: Do not put a Laptop or other wireless device (cell phone, cell phone, audio device, etc.) on top of or near the center console (between the seats to the dash). The Low Frequency (LF) antenna is below the center console and these devices may interrupt programming. Make sure that the key fob that is being programmed is inside the car away from nearby consumer electronics. Disconnect aftermarket cell phone chargers before attempting to program the key fob.

Remove all other keyfobs from inside the vehicle, except the keyfob that you want to program to the vehicle.
The keyfobs must be touching the KIN but the button cannot be depressed until instructed by the scan tool routine.
Be prepared to press the RKE Unlock button on the keyfob when prompted towards the end of the programming routine.

PROCEDURE

If the vehicle is equipped with a RF-Hub, perform the following procedure to program the keyfob:

Connect the scan tool.
Connect and confirm you have a network connection.
Navigate to RF-Hub and then the "Misc Functions" menu.
To add a new FOBIK select and perform "Enable Fobiks" and follow the screen prompts to program the keys/fobs to the vehicle.