Sensor, Air Temperature, Intake: Removal: 1.4L

NOTE:

This sensor monitors both Inlet Air Temperature (IAT) and Manifold Air Pressure (MAP).

Disconnect and isolate the negative battery cable.
Remove the engine cover.
Remove the air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL .

Fig 1: IAT/MAP Sensor Harness Connector
Courtesy of CHRYSLER GROUP, LLC
Unlock and disconnect the wire harness connector (1) from the IAT/MAP sensor.
Remove the bolt and the IAT/MAP sensor from the intake manifold.

Fig 2: IAT/MAP Sensor O-Ring
Courtesy of CHRYSLER GROUP, LLC
The IAT/MAP sensor O-ring (1) can be reused if not damaged.