LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2010 >> Taurus SE >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat System >> Removal And Installation >> Seat Control Switch - Front >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Seat Control Switch - Front: Installation

All seats 

  1. If equipped, position the seat control switch, the cover and install the 4 screws.
  2. If equipped, align the seat control switch to the cushion side shield and push in, engaging the retaining clips.
    • Install the buttons.
  3. Install the cushion side shield in the following sequence.
    1. Return all retaining clips back to the cushion side shield before installing the shield.
    2. Connect the memory SET switch electrical connector (if equipped).
    3. Connect the seat control switch electrical connector, if equipped with 6- or 10-way power seat.
    4. Attach the hook retainer behind the cushion frame, if equipped.
    5. Align the cushion side shield to the bracket, slide rearward and engage (if equipped).
    6. Align and attach the 3 retaining clips.
    7. Install the screw at the front.
    8. Install the screw at the back.
    9. Install the scrivet at the back.
  4. If equipped, from the front of the seat, connect the seat control switch electrical connectors and attach the wire harness retainer.
  5. If equipped, install the manual lumbar handle in the following sequence.
    1. Install the clip onto the manual lumbar handle.
    2. Align the splines of the manual lumbar handle to the manual lumbar shaft.
    3. Push the manual lumbar handle onto the manual lumbar shaft, seating the clip.
  6. If equipped, install the manual recliner handle in the following sequence.
    1. Install the clip onto the manual recliner handle.
    2. Align the splines of the manual recliner handle to the manual recliner shaft.
    3. Push the manual recliner handle onto the manual recliner shaft, seating the clip.
  7. Attach the carpet flap toe-kick retainers under the seat.
  8. Install the safety belt anchor bolt.
    • Tighten to 48 Nm (35 lb-ft).
    • For passenger seat, connect the BTS  electrical connector.
  9. Install the cushion side shield cover.

    All passenger seats 

  10. NOTE: To identify the Occupant Classification Sensor (OCS) system, refer to SEAT - EXPLODED VIEW, FRONT .

Carry out the Occupant Classification Sensor (OCS) System Reset. For additional information, refer to GENERAL PROCEDURES .

scientia non olet · About LEMON Manuals