Erasing DTC Memory Using SCS Service Connector
- Turn ignition switch to OFF position. Connect SCS Service Connector (07PAZ-0010100) to Memory Erase Signal (MES) connector. See Fig 1.
- Turn ignition switch to ON position. AIR BAG warning light will come on for about 6 seconds then go off.
- Disconnect SCS service connector from MES connector within 4 seconds after AIR BAG warning light goes off. AIR BAG warning light will come on again.
- Reconnect SCS service connector to MES connector within 4 seconds after AIR BAG warning light comes on. AIR BAG warning light will go off.
- Disconnect SCS service connector from MES connector within 4 seconds. AIR BAG warning light will indicate that memory is erased by blinking 2 times.
- Turn ignition switch to OFF position, and wait 10 seconds before proceeding with troubleshooting.
Courtesy of AMERICAN HONDA MOTOR CO., INC.