DTC B1061: Relay Control Module Lost Communication with Gauge Control Module (A/T message)
NOTE:
If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A (see
TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A
).
- Clear the DTCs with the HDS.
- Turn the ignition switch to LOCK (0), and then back to ON (II).
- Wait for 6 seconds or more.
- Check for DTCs with the HDS.
Is DTC B1061 indicated?
YES - Go to step 5.
NO - Intermittent failure, the communication line is OK at this time.
- Check for DTCs with the HDS.
Are DTCs B1008, B1808, B1956, B2011, and B2061 also indicated?
YES - Go to gauge control module input test (see GAUGE CONTROL MODULE INPUT TEST .
NO - Go to relay control module input test (see RELAY CONTROL MODULE INPUT TEST ).