LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2007 >> Ridgeline RT >> Repair and Diagnosis >> Engine Performance >> System >> PGM-FI System >> DTC Troubleshooting >> DTC P1172: Rear A/F Sensor (Bank 1, Sensor 1) Circuit Out of Range High; DTC P1174: Front A/F Sensor (Bank 2, Sensor 1) Circuit Out of Range High
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC P1172: Rear A/F Sensor (Bank 1, Sensor 1) Circuit Out of Range High; DTC P1174: Front A/F Sensor (Bank 2, Sensor 1) Circuit Out of Range High

NOTE:
  • Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see DTC TROUBLESHOOTING INDEX ).
  • Information marked with an asterisk (*) applies to the front bank (Bank 2).
  1. Turn the ignition switch ON (II).
  2. Clear the DTC with the HDS.
  3. Start the engine. Hold the engine speed at 3,000 RPM without load (in Park or neutral) until the radiator fan comes on, then let it idle.
  4. Monitor the OBD STATUS for P1172 and/or P1174* in the DTCs MENU with the HDS.

    Does the screen indicate FAILED? 

    YES  - Go to step 5.

    NO  - If the screen indicates PASSED, intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the A/F sensor (Sensor 1) and the PCM. If the screen indicates EXECUTING, keep driving until a result comes on. If the screen indicates OUT OF CONDITION, go to step  3 and recheck.

  5. Turn the ignition switch OFF.
  6. Replace the A/F sensor (Sensor 1) (see A/F SENSOR REPLACEMENT  ).
  7. Turn the ignition switch ON (II).
  8. Reset the PCM with the HDS.
  9. Do the PCM idle learn procedure (see PCM IDLE LEARN PROCEDURE ).
  10. Start the engine. Hold the engine speed at 3,000 RPM without load (in Park or neutral) until the radiator fan comes on, then let it idle.
  11. Check for Temporary DTCs or DTCs with the HDS.

    Is DTC P1172 and/or P1174* indicated? 

    YES  - Check for poor connections or loose terminals at the A/F sensor (Sensor 1) and the PCM, then go to step  1.

    NO  - Go to step 12.

  12. Monitor the OBD STATUS for DTC P1172 and/or P1174* in the DTCs MENU with the HDS.

    Does the screen indicate PASSED? 

    YES  - Troubleshooting is complete. If any other Temporary DTCs or DTCs were indicated in step  11, go to the indicated DTCs troubleshooting.

    NO  - If the screen indicates FAILED, check for poor connections or loose terminals at the A/F sensor (Sensor 1) and the PCM, then go to step  1. If the screen indicates EXECUTING or OUT OF CONDITION, keep idling until a result comes on.

scientia non olet · About LEMON Manuals