LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2009 >> S2000 Base >> Repair and Diagnosis >> Brakes >> Traction Control >> VSA (Vehicle Stability Assist) System Components >> VSA Modulator-Control Unit Removal and Installation >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

VSA Modulator-Control Unit Removal and Installation: Installation

  1. Install the VSA modulator-control unit on the bracket.
  2. Install the bracket with the VSA modulator-control unit to the body.
  3. Reconnect the six brake lines, then tighten the flare nuts to the specified torque.
  4. Align the connecting surface of the VSA modulator-control unit 47P connector to the VSA modulator-control unit.
  5. Pull up the lock of the VSA modulator-control unit 47P connector, then confirm the connector is fully seated.
  6. Bleed the brake system (see BRAKE SYSTEM BLEEDING ).
  7. Do the VSA sensor neutral position memorization (see SENSOR CLUSTER REPLACEMENT ).
  8. Start the engine, and make sure the ABS and VSA indicators go off.
  9. Test-drive the vehicle, make sure the ABS and VSA indicators do not come on.
NOTE: If the brake pedal is spongy, there may be air trapped in the modulator which could then be induced into the normal brake system during modulation. Bleed the brake system again (see BRAKE SYSTEM BLEEDING ).
scientia non olet · About LEMON Manuals