DTC 1302: GPS Receiver Error 1 (2014-15)

NOTE: 

• First, check the Vehicle 12 volt battery condition .
• This navigation DTC sets when there is an internal GPS receiver problem (freeze error).
• Before you troubleshoot, make sure to follow the General Troubleshooting Information - Refer to: How to Troubleshoot the Navigation System (2014-15) .
• Make sure the vehicle is parked outside, away from buildings.
• Aftermarket electronic devices located near the audio-navigation unit or GPS antenna can potentially interfere with the operation of the navigation system.
• Check any official Honda service website for more service information about the navigation system.
• Check the connectors for poor connections or loose terminals.

1. Problem verification

   -1. Clear the hard error codes.

   - 2. Turn the vehicle to the OFF (LOCK) mode.

   - 3. Turn the vehicle to the ON mode, and wait at least 1 minute.

   - 4. Check for hard error codes.

   Is DTC 1302 indicated?

   YES 

   Check for poor connections or loose terminals. If the connection is OK, Replace the audio-navigation unit - Refer to: Audio-Navigation Unit Removal and Installation (2014-15) .

   NO 

   Intermittent failure, the system is OK at this time.