Immobilizer indicator does not go off
WARNING: This page is about a different variant/trim than selected.
- Immobilizer system check
-1. Turn the ignition switch to LOCK (0).
- 2. Connect the HDS to the data link connector (DLC).
- 3. Turn the ignition switch to ON (II).
- 4. From the SYSTEM SELECTION MENU, enter IMMOBI, then select IMMOBILIZER INFO.
NOTE: If the HDS does not communicate with the immobilizer-keyless control unit, check the power, ground, and K-line connections.
Immobilizer - Information/Record Data/History Data - Immobilizer Information
Perform the SYSTEM CHECK from the IMMOBILIZER INFO.
Is N-1 OK indicated?
YES
Replace the gauge control module .
NO