DTC U0311: Traction Motor Control Module Program Version Mismatch (123)
General Description
The motor control processor and the generator control processor software which are in the motor control module (traction) can be updated by software rewriting device connected via the F-CAN lines. When both processors need to be updated but either processor fails rewriting, the indicator comes on and stores a DTC. Each processor stores a program version information, and compare their versions each other by transmitting/receiving via the internal serial communication. If the motor control processor judges that its own software version is old, a malfunction is detected and a DTC is stored.
Monitor Execution, Sequence, Duration, DTC Type, OBD Status
| Execution | Continuous |
| Sequence | None |
| Duration | 1 second or more |
| DTC Type | One drive cycle, MIL on, POWER SYSTEM indicator on |
| OBD Status | PASSED/FAILED/NOT COMPLETED (STILL TESTING) |
Enable Conditions
| Condition | ||
|---|---|---|
| Vehicle | ON mode | |
Malfunction Threshold
The motor control processor judges that its own software version is old for at least 1 second.
Possible Cause
NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
- Abnormal combination the motor control module (generator) and motor control module (traction)
Diagnosis Details
Conditions for setting the DTC
When a malfunction is detected, the MIL comes on and a Pending DTC, a Confirmed DTC, and the freeze data are stored in the motor control module (traction) memory.
Conditions for clearing the DTC
The MIL is cleared if the malfunction does not return in three consecutive trips in which the diagnostic runs. The MIL, the Pending DTC, the Confirmed DTC, and the freeze data can be cleared with the scan tool Clear command or by disconnecting the 12 volt battery.