Steering Angle Sensor Neutral Position Clear: Procedure

NOTE: The steering angle sensor neutral position must be cleared whenever the steering joint, the steering wheel, or the steering angle sensor is removed or if the front toe is adjusted.

HDS DLC - Connect

Courtesy of HONDA, U.S.A., INC.

1. Turn the vehicle to the ON mode, but do not turn the vehicle to the READY TO DRIVE mode.

2. Connect the MVCI to the data link connector (DLC) (A) located under the driver's side of the dashboard.

NOTE: Update cannot be done when the HDS is connected to the MVCI.

3. Make sure the MVCI communicates with the vehicle. If it does not communicate, go to the DLC circuit troubleshooting - Refer to: DLC Circuit Troubleshooting(PGM-FI System) (2014 2015), or DLC Circuit Troubleshooting(PGM-FI System) (2017)

Steering Angle Sensor Neutral Position - Clear

1. Select EPS ADJUSTMENT, then select EPS STEERING ANGLE SENSOR VALUE CLEAR and follow the screen prompts on the HDS.

NOTE: See the HDS Help menu for specific instructions.