Gear Unit Control System DTC Troubleshooting Index (2014 2015)
NOTE:
Before you troubleshoot, review the General Troubleshooting Information - Refer to: How to Troubleshoot the Fuel and Emissions Systems (2014 2015),
or How to Troubleshoot the Gear Unit Control System, or How to Troubleshoot the Fuel and Emissions Systems (2017)
.
| DTC *(1) | Two Drive Cycle Detection | Shift Position Indicator | MIL | Detection Item |
|---|---|---|---|---|
| P0705 (5) *(2) | - - - | Blinks | OFF | Transmission Range Switch (Multiple Shift - Position Input) |
| P0706 (6) *(2) | ◦ | Blinks | OFF | Transmission Range Switch (Open) |
| P0751 (70) | ◦ | Blinks | OFF | Shift Solenoid Valve A Stuck OFF |
| P0752 (70) | ◦ | Blinks | OFF | Shift Solenoid Valve A Stuck ON |
| P0756 (71) | ◦ | Blinks | OFF | Shift Solenoid Valve B Stuck OFF |
| P0757 (71) | ◦ | Blinks | OFF | Shift Solenoid Valve B Stuck ON |
| P0811 (181) | ◦ | Blinks | OFF | Excessive Clutch "A" Slippage |
| P0842 (25) - Refer to: DTC Troubleshooting: P0842 (2014 2015), or DTC Troubleshooting: P0842 (2017) *(2) | ◦ | Blinks | OFF | Transmission Fluid Pressure Switch A Circuit Low |
| P0843 (25) - Refer to: DTC Troubleshooting: P0843 (2014 2015), or DTC Troubleshooting: P0843 (2017) *(2) | ◦ | Blinks | OFF | Transmission Fluid Pressure Switch A Circuit High |
| P0847 (26) *(2) | ◦ | Blinks | OFF | Transmission Fluid Pressure Switch B Circuit Low |
| P0848 (26) *(2) | ◦ | Blinks | OFF | Transmission Fluid Pressure Switch B Circuit High |
| P0973 (7) *(2) | - - - | Blinks | OFF | Shift Solenoid Valve A (Short) |
| P0974 (7) *(2) | - - - | Blinks | OFF | Shift Solenoid Valve A (Open) |
| P0976 (8) *(2) | - - - | Blinks | OFF | Shift Solenoid Valve B (Short) |
| P0977 (8) *(2) | - - - | Blinks | OFF | Shift Solenoid Valve B (Open) |
| P1717 (62) *(2) | ◦ | Blinks | OFF | Transmission Range Switch ATP RVS Switch (Open) |
| P1718 (68) *(2) | ◦ | Blinks | OFF | Transmission Range Switch ATP RVS2 Switch (Open) |
| P2801 (48) *(2) | ◦ | Blinks | OFF | Transmission Range Switch ATP FWD2 Switch (Open) |
NOTE:
*(1): The DTC in parentheses is the flash code the shift position indicator indicates when the data link connector (DLC) is connected to the HDS, and in the SCS mode.
*(2): This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the gear controls.