DTC 1305: Gyro Error 2: ECU Temp XX °C (2014-15)
NOTE:
- First, check the Vehicle 12 volt battery condition .
- This navigation DTC sets when there is a problem with the internal gyro (refer to Yaw Sensor diagnosis), and indicates the navigation ECU temperature when the DTC is detected.
- Before you troubleshoot, make sure to follow the General Troubleshooting Information - Refer to: How to Troubleshoot the Navigation System (2014-15) .
- Make sure the vehicle is parked outside, away from buildings.
- Aftermarket electronic devices located near the audio-navigation unit or GPS antenna can potentially interfere with the operation of the navigation system.
- Do this test only when the dash temperature is between -4 °F (-20 °C) and 158 °F (70 °C).
- Check that the fan screen on the back of the audio-navigation unit is not blocked. Clean it if necessary.
- Check any official Honda service website for more service information about the navigation system.
- Problem verification
-1. Check that the temperature is below 70 °C (158 °F) in the dash.
- 2. Clear the hard error codes.
- 3. Turn the vehicle to the OFF (LOCK) mode.
- 4. Turn the vehicle to the ON mode, and wait at least 3 minutes.
- 5. Check for hard error codes.
Is DTC 1305 indicated?
YES
Replace the audio-navigation unit - Refer to: Audio-Navigation Unit Removal and Installation (2014-15) .
NO
Intermittent failure, the system is OK at this time.