DTC 2701: GPS Diag: Antenna (With Display Audio) (2017)
NOTE:
- First, check the Vehicle 12 volt battery condition .
- This navigation DTC sets when there is poor connectors or loose terminals at the GPS antenna connector or an open in GPS antenna lead.
- Before you troubleshoot, make sure to follow the General Troubleshooting Information - Refer to: How to Troubleshoot the Navigation System (With Display Audio) (2017) .
- Make sure the vehicle is parked outside, away from buildings.
- Aftermarket electronic devices located near the audio-navigation unit or GPS antenna can potentially interfere with the operation of the navigation system.
- Check the connectors for poor connections or loose terminals.
- Problem verification
-1. Clear the hard error codes.
- 2. Turn the vehicle to the OFF (LOCK) mode.
- 3. Turn the vehicle to the ON mode, and wait at least 1 minute.
- 4. Check for hard error codes.
Is DTC 2701 indicated?
YES
The failure is duplicated, go to step 2.
NO
Intermittent failure, the system is OK at this time.
- GPS antenna check (substitution)
-1. Clear the hard error codes.
- 2. Turn the vehicle to the OFF (LOCK) mode.
- 3. Substitute a known-good GPS antenna.
- 4. Turn the vehicle to the ON mode, and wait at least 1 minute.
- 5. Check for hard error codes.
Is DTC 2701 indicated?
YES
Replace the audio-navigation unit - Refer to: Audio-Navigation Unit Removal and Installation (With Display Audio) (2017) .
NO