DTC 2703: Aircon Diag (With Display Audio) (2017)

NOTE: 

• First, check the Vehicle 12 volt battery condition .
• This navigation DTC sets when Connection NG is indicated in the Aircon diagnosis (the A/C icon is red in the System Links).
• Check for B-CAN DTCs and resolve them before troubleshooting.
• Before you troubleshoot, make sure to follow the General Troubleshooting Information - Refer to: How to Troubleshoot the Navigation System (With Display Audio) (2017) .
• Check the connectors for poor connections or loose terminals.

1. Problem verification

   -1. Clear the hard error codes.

   - 2. Turn the vehicle to the OFF (LOCK) mode then the ON mode.

   - 3. Check for hard error codes.

   Is DTC 2703 indicated?

   YES 

   The failure is duplicated, go to step 2.

   NO 

   Intermittent failure, the system is OK at this time.

2. Open wire check (B-CAN_H, B-CAN_L lines)

   -1. Turn the vehicle to the OFF (LOCK) mode.

   - 2. Disconnect the following connectors.

   Audio-navigation unit connector B (20P)

   Climate control unit connector A (32P)

   - 3. Check for continuity between test points 1 and 2.

   Test condition	Vehicle OFF (LOCK) mode
   	Audio-navigation unit connector B (20P): disconnected
   	Climate control unit connector A (32P): disconnected
   Test circuit 1
   Test point 1	Audio-navigation unit connector B (20P) No. 3 - Refer to: Audio-Navigation Unit Connector for Inputs and Outputs (With Display Audio) (2017)
   Test point 2	Climate control unit connector A (32P) No. 30 - Refer to: Climate Control Unit Connector for Inputs and Outputs (2015, 2017)

   Test circuit 2
   Test point 1	Audio-navigation unit connector B (20P) No. 13 - Refer to: Audio-Navigation Unit Connector for Inputs and Outputs (With Display Audio) (2017)
   Test point 2	Climate control unit connector A (32P) No. 32 - Refer to: Climate Control Unit Connector for Inputs and Outputs (2015, 2017)

   Is there continuity?

   YES 

   The B-CAN_H wire and the B-CAN_L wires are OK. Go to step 3.

   NO 

   Repair an open in the wire (s) between the audio-navigation unit and the climate control unit.

3. Climate control unit check (substitution)

   -1. Substitute a known-good climate control unit.

   - 2. Reconnect all the connectors.

   - 3. Clear the hard error codes.

   - 4. Turn the vehicle to the OFF (LOCK) mode then the ON mode.

   - 5. Check for hard error codes.

   Is DTC 2703 indicated?

   YES 

   Replace the audio-navigation unit - Refer to: Audio-Navigation Unit Removal and Installation (With Display Audio) (2017) .

   NO 

   Replace the original climate control unit .