Immobilizer indicator does not go off or does not come on

WARNING: This page is about a different variant/trim than selected.

Keyless access system check 1
-1. Press the engine start/stop button to select the OFF mode.

- 2. Press the engine start/stop button to select the ON mode.

- 3. Check the immobilizer indicator.

Does the immobilizer indicator come on?

YES

Go to step 2.

NO

Go to step 5.
Keyless access system check 2
-1. Check the immobilizer indicator.

Does the indicator come on, then go off?

YES

Go to step 3.

NO

Go to step 6.
Keyless access system check 3
-1. With driver's power window open and all the doors closed, press the engine start/stop button to select the OFF mode.

- 2. Remove all the keyless remotes from inside the vehicle. Hold them outside the open driver's window, at least 8.0 in (20 cm) away from the vehicle.

- 3. Press the engine start/stop button. The MID should request the keyless remote to touch the engine start/stop button. The LED on the engine start/stop button will flash for up to 30 seconds.

- 4. Touch the engine start/stop switch with the keyless remote. The buttons on the keyless remote should be facing you. The LED on the engine start/stop button will turn solid when detected.

- 5. Press the engine start/stop button to select the ON mode.

- 6. Check the immobilizer indicator.

Does the indicator blink once, then stay off?

YES

Intermittent failure, the system is OK at this time.

NO

Go to step 4.
Keyless access system check 4
-1. Select BACKUP CONTROL UNIT from the ONE-PUSH START system select menu with the HDS, and enter SYSTEM INFORMATION.

One-Push - BACKUP CONTROL UNIT - System Information

Perform the SYSTEM CHECK with the HDS.

Is N-1 OK indicated?

YES

Replace the gauge control module .

NO

Troubleshoot the keyless access system according to the result of the SYSTEM CHECK.
PGM-FI system check
-1. Check the malfunction indicator lamp (MIL).

Does the indicator come on?

YES

Troubleshooting the PCM DTCs.

NO

Replace the gauge control module .
Keyless access system check 3
-1. Select KEYLESS ACCESS CONTROL UNIT from the ONE-PUSH START system select menu with HDS, and enter SMART INFORMATION.

One-Push - KEYLESS ACCESS CONTROL UNIT- Smart Information

Perform the SYSTEM CHECK 1 and 2 with the HDS.

Is N-1 OK indicated?

YES

Replace the gauge control module .

NO

Troubleshoot the keyless access system according to the result of the SYSTEM CHECK 1 and 2.