DTC 2611: HDD Diag
WARNING: This page is about a different variant/trim than selected.
NOTE:
- Check the vehicle battery condition first .
- This navigation DTC sets when there is a problem with the HDD (the HDD icon is red in the System Link).
- If the audio-navigation unit displays an error message when you turn on the navigation system, follow the instructions - Refer to: Navigation System Error Messages, or Navigation System Error Messages (Display Audio) (2016-17) .
- Check any official Honda service website for more service information about the navigation system.
- Before you troubleshoot, make sure to follow the General Troubleshooting Information - Refer to: How to Troubleshoot the Navigation System, or How to Troubleshoot the Navigation System (Display Audio) (2016-17) .
- Problem verification
-1. Clear the hard error codes.
- 2. Press the engine start/stop button to select the OFF mode and then select the ON mode.
- 3. Check for hard error codes.
Is DTC 2611 indicated?
YES
The failure is duplicated, go to step 2.
NO
Intermittent failure, the system is OK at this time.
- Determine possible failure area (audio-navigation unit, others)
-1. Go into the System Diagnostic Mode, and select the HDD in the System Links to check the HDD Status.
Is HDD status OK indicated?
YES
Intermittent failure, the system is OK at this time.
NO