Real Time AWD System Bleeding: Procedure

NOTE: Whenever the rear differential assembly is disassembly, its real time AWD system must be bled.

HDS DLC - Connection
1. Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.
2. Turn the ignition switch to ON (II).
3. Make sure the HDS communicates with the vehicle. If it does not communicate, go to the DLC circuit troubleshooting.
  
  Fig 1: Identifying Data Link Connector
  Courtesy of AMERICAN HONDA MOTOR CO., INC.
Real Time AWD System Bleeding
1. Select the ADJUSTMENT in the REAL TIME AWD SYSTEM with the HDS.
2. Select the AIR BLEEDING in the ADJUSTMENT with the HDS.
  NOTE: See the HDS Help menu for specific instructions.