Immobilizer indicator blinks

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2020 Honda Fit, 2019 Honda Fit, 2018 Honda Fit, 2017 Honda Fit, and 2016 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Before troubleshooting, check the items listed in General Check before Troubleshooting .

Immobilizer system check:
- 1. Connect the HDS to the data link connector (DLC) .

- 2. Turn the vehicle to the ON mode.

- 3. From the SYSTEM SELECTION MENU, enter IMMOBI, then select IMMOBILIZER SETUP.

NOTE: If the HDS does not communicate with the immobilizer-keyless control unit, check the power, ground, and K line connections.

Immobilizer - Information/Record Data/History Data - Immobilizer Information

- 4. Select the SYSTEM CHECK from the IMMOBILIZER INFO.

Is SYSTEM CHECK indicated?

YES

Troubleshoot the immobilizer system according to the results of the SYSTEM CHECK .

NO

Go to step 2.
Open wire check (GND line):
- 1. Turn the vehicle to the OFF (LOCK) mode.

- 2. Enter the vehicle, and remove the ignition key from the ignition switch, then close all the doors.

- 3. Operate the keyless transmitter LOCK and UNLOCK several times in the vehicle.

Do the door lock actuators work normally?

YES

The GND wire is OK. Go to step 3.

NO

Repair an open or high resistance in the ground wire or poor ground (G401).

Open wire check (IG1 FUEL PUMP line):

- 1. Turn the vehicle to the ON mode.

- 2. Measure the voltage between test points 1 and 2.

Test condition	Vehicle ON mode.
Test point 1	Immobilizer-keyless control unit 7P connector No. 6
Test point 2	Body ground

Is there battery voltage?

YES

The IG1 FUEL PUMP wire is OK. Replace the immobilizer-keyless control unit .

Repair an open or high resistance in the wire.