Troubleshooting - B-CAN System Diagnosis Test Mode C

WARNING: This page is about a different car, the 2011 Honda Pilot, 2010 Honda Pilot, and 2009 Honda Pilot. However, it is still accessible from the selected car via links, so may be relevant.

Do this diagnosis if a component that is controlled by the B-CAN system does not stop or turn off.

NOTE:

If the component does not turn ON, go to TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE D .
See the B-CAN system unit input/output index for a list of input and output devices and the control units that monitor the input and control the output devices (see SYSTEM DESCRIPTION ).

Check for DTCs by selecting the TEST MODE menu from the HDS.
Are any DTCs indicated?

YES - Go to TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A . ■

NO - Go to step 2.
Turn OFF the switch that controls the malfunctioning component.
Select DATA LIST from the TEST MODE menu, and check the input of the switch that controls the component.
Does the HDS indicate the switch is OFF?

YES - Go to step 4.

NO - Go to step 6.
In DATA LIST, check the output signal of the malfunctioning component.
Is the output signal OFF?

YES - Go to step 5.

NO - Replace the control unit that controls the device that will not turn OFF. ■
Check the relay if applicable, then check for a short in the wire between the relay and the component, the relay and control unit, or the component and control unit.
Are the relay and the wire harness OK?

YES - Replace the control unit that controls the component that will not turn OFF. ■

NO - Replace the relay or repair the wire harness. ■
Check the switch, then check for a short in the wire between the switch and the control unit that monitors the switch.

the switch and wire harness OK?

YES - Replace the control unit that monitors the switch. ■

NO - Replace the switch or repair the wire harness. ■