Factory diagnostic screen In Line Diag
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2014 Honda Ridgeline, 2013 Honda Ridgeline, 2012 Honda Ridgeline, 2011 Honda Ridgeline, and 2010 Honda Ridgeline. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If the vehicle left the factory in the factory diagnosis mode, or if the navigation unit is replaced, you will see this screen every time you turn on the ignition. You may also see this screen if you recently replaced the navigation unit.
When a navigation control unit is powered up for the first time at the factory, the factory diagnosis screen (In Line Diag) appears. Normally the factory performs the steps necessary to verify proper operation and terminate the factory diagnostic.
Until the proper confirmation sequence is performed, the screen appears every time the vehicle is started.
Follow the steps below to prevent the screen from showing up in the future:
- Press and hold down the buttons MENU, MAP/GUIDE, and the CANCEL for about 3 seconds (the Select Diagnosis items screen appears).
- Press and hold down the MAP/GUIDE button for 5-10 seconds a screen with a Complete button, appears.
- Touch Complete, and then the Return button (the system may re-boot).
- Restart the vehicle, and confirm normal operation by completing the "PDI of the Navigation System" Service Bulletin.