Interface Dial Removal/Installation

WARNING: This page is about a different car, the 2011 Honda Pilot, 2010 Honda Pilot, and 2009 Honda Pilot. However, it is still accessible from the selected car via links, so may be relevant.

Remove the navigation switch panel and the center pocket (see NAVIGATION DISPLAY UNIT REMOVAL/INSTALLATION ).
Remove the screw and harness cover (A). Then disconnect the interface dial 13P connector (B).

Fig 1: Identifying Harness Cover, Interface Dial 13P Connector, Screws, Knob & Interface Dial
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the 4 screws (C), then remove the knob (D) and the dial (E) from the interface dial (F) with two KTC trim tools and applying even force as shown.
NOTE: Apply pressure slowly and steady until the knob and dial pops off.
Install the dial in reverse order of removal.
NOTE: If the hard buttons do not work, but the jog dial does, recheck the interface dial connector connection.