Component Inspection

Measure resistance between terminals 1 and 2 of OTS connector (Component side).

Specification

TEMPERATURE AND RESISTANCE SPECIFICATION

Temp.(°C)	Temp.(°F)	OTS Resistance (kΩ)	Temp.(°C)	Temp.(°F)	OTS Resistance (kΩ)
-20	-4	Approx. 14.1~16.9	40	104	Approx. 1.1~1.2
0	32	Approx. 6	60	140	Approx. 0.5~0.6
20	68	Approx. 2.3~2.6	80	176	Approx. 0.3

Fig 1: Measuring Resistance Between OTS Connector Terminal 1 And 2

Courtesy of HYUNDAI MOTOR CO.

Is resistance within specification?
YES
- Check for poor connection between ECM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure
NO
- Check OTS for contamination, deterioration, or damage. Substitute with a known-good OTS and check for proper operation. If the problem is corrected, replace OTS and then go to "VERIFICATION OF VEHICLE REPAIR " procedure