Verification of Vehicle Repair

After repairing, it is essential to verify that the fault has been corrected.

1. Vehicle Parked & Ignition ON.
2. After connecting GDS select "Diagnostic Trouble Codes(DTC)"  Analysis mode.
3. Clear recorded DTC using GDS.
4. Operate the system within DTC "Enable Conditions" in "General Information".
5. After selecting "Diagnostic Trouble Codes(DTC)"  mode, check if DTC is recorded again.
6. Are any DTC's recorded?

   YES 

   • Go to the applicable Troubleshooting Procedure.

   NO 

   • System is performing to specification at this time.