LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2015 >> Veloster Base, Standard Trans >> Repair and Diagnosis (Single Page) >> Brakes >> Traction Control >> Electronic Stability Control (ESC) System >> Troubleshooting >> Communication With GDS Is Not Possible (Communication With ABS Only Is Not Possible.) >> Inspection Procedures >> Check The Power Source Of ESC Control Module
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Check The Power Source Of ESC Control Module

  1. Disconnect the Connector from the ESC Control Module.
  2. Turn the Ignition Switch ON, measure the Voltage between Terminal 29 of the ESC Control Module Harness Side Connector and Body Ground.

    Specification  : Approximately B+

    Fig 1: Measuring Voltage Between ESC Control Module Harness Side Connector Terminal And Body Ground
    G10605160Courtesy of HYUNDAI MOTOR AMERICA
  3. Is Voltage within specification?

    YES 

    • Check for poor ground.

    NO 

    • Check the Harness or Connector between the Fuse (10A) in the Engine Compartment Junction Block and the ESC Control Module. Repair if necessary.
scientia non olet · About LEMON Manuals