Repair Procedures: Installation

CAUTION:

Place the shift lever and transaxle side lever in 4th shift position and insert the lever fixing pin (A).

Fig 1: Inserting Lever Fixing Pin

Courtesy of HYUNDAI MOTOR AMERICA

Install the retainer (A) and then tighten nut (B-2 ea).
Tightening torque:

11.8 - 14.7 N.m (1.2 - 1.5 kgf.m, 8.7 - 10.8 lb-ft)

Fig 2: Installing Retainer
Courtesy of HYUNDAI MOTOR AMERICA
Install the select cable (B), and then fixing the snap pin (A).

Fig 3: Installing Select Cable And Snap Pin
Courtesy of HYUNDAI MOTOR AMERICA
Install the shift cable (A).

Fig 4: Installing Shift Cable
Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
- After installing the select cable and shift cable socket, check portion (A) to see if it projects outwards from the cap. Refer to (Fig 5).
Fig 5: Installing Select Cable And Shift Cable Socket
Courtesy of HYUNDAI MOTOR AMERICA
Move the locker (B) in the direction of "F" with pulling the holder (A) in the direction of "P".

Fig 6: Moving Locker And Pulling Holder
Courtesy of HYUNDAI MOTOR AMERICA
Install the shift cable (B) and select cable (C), and then fixing the snap pin (A-2 ea).

Fig 7: Installing Shift Cable, Select Cable And Snap Pins
Courtesy of HYUNDAI MOTOR AMERICA
Tighten the holder (A) to the "P" directions after fixing the rockers (B) in the "F" direction.

Fig 8: Tighten Holder To "P" Direction After Fixing Rockers In "F" Direction
Courtesy of HYUNDAI MOTOR AMERICA
Remove the shift lever 4th fixed pin (A).

Fig 9: Removing Shift Lever 4th Fixed Pin
Courtesy of HYUNDAI MOTOR AMERICA
Install the floor console assembly.
(Refer to Body - "FLOOR CONSOLE ")
Install the battery and battery tray.
(Refer to Engine Electrical System - "BATTERY ")
Install the engine control module (ECM).
(Refer to Engine Control System - "Engine Control Module (ECM) ")
Install the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "AIR CLEANER ")
CAUTION:
- Check operating of lever of transaxle side when operating shift lever after assembly. (1-6, R)
- If there is sticky feel, adjust the control cable length again.
  (Refer to Control Cable - "INSTALLATION ")