Programming Remote Controller
- New Identity (ID) code must be manually entered whenever replacing remote controller or LCU 05, or when adding additional remote controller(s). To enter ID code, perform steps 2) and 3).
- Close and lock all doors. Erase original ID code(s) by inserting and removing key from ignition switch more than 6 times within 10 seconds. Hazard warning lights should flash twice.
- Turn ignition switch to ACC position. Push any lock button on new remote controller once. Hazard warning lights should flash twice, indicating ID code for new remote controller has been entered.
- To enter additional remote controller ID code(s), unlock driver's door, then lock it using door lock switch in vehicle. Press lock button on new remote controller once to enter ID code.
- A maximum of 4 remote control ID codes can be entered. If same ID code is entered more than once, the entry is ignored even though hazard warning lights will still flash twice. To exit programming (ID entry) mode, unlock and open driver's door.