Programming New Id Code
NOTE:
This procedure will erase all previous ID codes and render all previously programmed remote controllers inoperative (until reprogrammed). All remote controllers to be used with system MUST be programmed at the same time.
NOTE:
A maximum of 4 remote controls can be programmed, and any attempt to program more will be ignored. If same ID code is entered more than once, the entry is ignored, even though hazard warning lights will still flash twice.
- Close and lock all doors. Erase original ID code(s) by inserting and removing key from ignition switch more than 6 times within 10 seconds. Hazard warning lights should flash twice. Turn ignition switch to ACC position.
- Push any button on new remote controller once. Hazard warning lights should flash twice, indicating ID code has been entered. If Identity (ID) code cannot be entered, perform DIAGNOSTIC PROCEDURE NO. 2 under SYSTEM TESTS.
- If additional remote controllers are to be used, repeat step 2) for each additional remote controller. If no additional remote controllers are to be used, exit programming mode by unlocking and opening driver's door.