Ignition Coil Resistance

Ignition coil is located in distributor. Disconnect distributor 2-pin harness connector. Remove distributor cap. Measure resistance between distributor 2-pin connector terminals. Also measure resistance between ignition coil tower and distributor 2-pin connector terminal No. 8. See Fig 1 . See IGNITION COIL RESISTANCE table.

IGNITION COIL RESISTANCE

Application

Resistance @ 77°F (25°C)

Primary ⁽¹⁾

About 0.8 Ohm

Secondary ⁽²⁾

About 16K/Ohms

⁽¹⁾	Measured between distributor 2-pin connector terminals.

⁽²⁾	See Fig 1 .

Fig 1: Measuring Ignition Coil Secondary Resistance

Courtesy of NISSAN MOTOR CO., U.S.A.