LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2003 >> FX45 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Servicing >> Removal & Installation >> Revolution Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Revolution Sensor: Installation

CAUTION: After completing installation, check for transmission fluid leakage and fluid level. See CHECKING FLUID LEVELS .
  1. Install revolution sensor in transmission case with bolt. See Figure. Tighten to specification. See TORQUE SPECIFICATIONS .
  2. Connect revolution sensor connector. See Figure.
  3. Securely fasten revolution sensor harness with clips.
  4. Apply recommended sealant to rear extension assembly as shown, see Fig 1. Completely remove all moisture, oil and old sealant from transmission case and rear extension assembly mounting surfaces.
  5. Install rear extension assembly to transmission case. (With needle bearing.)
  6. Tighten rear extension assembly mounting bolts to specification. See TORQUE SPECIFICATIONS . DO NOT reuse self-sealing bolts. See Figure.
  7. Install rear engine member. See appropriate FRONT SUSPENSION article in SUSPENSION.
  8. Install oil pan to transmission case using the following steps:
    1. Install oil pan gasket to oil pan. DO NOT reuse oil pan gasket. Install it in the direction to align hole positions. Completely remove all moisture, oil and old gasket from oil pan mounting surface.
    2. Install oil pan (with oil pan gasket) to transmission case. Install it so that drain plug comes to the position as shown. Use care to not pinch electrical harnesses.
    3. Tighten oil pan mounting bolts to specification in sequence shown after temporarily tightening them. See Fig 2. DO NOT reuse oil pan mounting bolts. See TORQUE SPECIFICATIONS .
  9. Install drain plug to oil pan. DO NOT reuse drain plug gasket. See TORQUE SPECIFICATIONS .
  10. Install rear drive shaft. See appropriate DIFFERENTIALS article in DRIVELINE/AXLES.
  11. Install front exhaust pipe and center exhaust pipe.
  12. Install front suspension member. See appropriate FRONT SUSPENSION article in SUSPENSION.
  13. Pour new transmission fluid into transmission case. See DRAINING & REFILLING .
  14. Connect negative battery terminal.
Fig 1: Applying Liquid Gasket
G00321804Courtesy of NISSAN MOTOR CO., U.S.A.
Fig 2: Transmission Oil Pan Tightening Sequence
G00321805Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals