CONSULT-II Function (BCM): Notes

CONSULT-II can display each diagnostic item using the diagnostic test modes shown following.

Fig 1: Consult-II - Display Each Diagnostic Item

Courtesy of NISSAN MOTOR CO., U.S.A.

1. Turn ignition switch "ON".
2. Connect "CONSULT-II and CONSULT-II CONVERTER" to the data link connector.
   Fig 2: Consult-II - Data Link Connector Display

   Courtesy of NISSAN MOTOR CO., U.S.A.
3. Turn ignition switch "ON".
4. Touch "START (NISSAN BASED VHCL)".
   Fig 3: Consult-II - Display

   Courtesy of NISSAN MOTOR CO., U.S.A.
5. Touch "BCM".

   If "BCM" is not indicated, go to Refer to "CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT "

   Fig 4: Consult-II - Display Select Test

   Courtesy of NISSAN MOTOR CO., U.S.A.
6. Touch "RETAINED PWR".
   Fig 5: Consult-II - Display Select Test Item

   Courtesy of NISSAN MOTOR CO., U.S.A.
7. Select diagnosis mode.

   "ACTIVE TEST", "WORK SUPPORT" and "DATA MONITOR" are available.

   Fig 6: Consult-II - Display Select Diag Mode

   Courtesy of NISSAN MOTOR CO., U.S.A.