CONSULT-II Function (BCM): Notes

CONSULT-II can display each diagnostic item using the diagnostic test modes shown following.

Fig 1: Consult-II Function (BCM) Chart

Courtesy of NISSAN MOTOR CO., U.S.A.

1. Turn ignition switch "OFF".
2. Connect "CONSULT-II" and CONSULT-II CONVERTER to data link connector.
   Fig 2: Connecting Consult-II And Consult-II Converter To Data Link Connector

   Courtesy of NISSAN MOTOR CO., U.S.A.
3. Turn ignition switch "ON".
4. Touch "START (NISSAN BASED VHCL)".
   Fig 3: Consult-II - Display

   Courtesy of NISSAN MOTOR CO., U.S.A.
5. Touch "BCM".

   If "BCM" is not indicated, go to "CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT "

   Fig 4: Consult-II - Select System Display

   Courtesy of NISSAN MOTOR CO., U.S.A.
6. Touch "REAR DEFOGGER".
   Fig 5: Consult-II - Select Test Item Display

   Courtesy of NISSAN MOTOR CO., U.S.A.
7. Select diagnosis mode, "DATA MONITOR" and "ACTIVE TEST" are available.
   Fig 6: Consult-II - Select Diag Mode Display

   Courtesy of NISSAN MOTOR CO., U.S.A.