Encoder Circuit Check (Rear LH Or RH)/With Front And Rear Power Window Anti-Pinch System

CHECK ENCODER SIGNAL
1. Turn ignition switch ON.
2. Check the signal between power window sub-switch (rear LH or RH) connector and ground with oscilloscope.
  
  Fig 1: Signal Check Between Power Window Sub-Switch (Rear LH Or RH) Connector And Ground With Oscilloscope Table
  Courtesy of NISSAN MOTOR CO., U.S.A.
  
  Fig 2: Checking Signal Between Power Window Sub-Switch (Rear LH Or RH) Connector And Ground With Oscilloscope
  Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
1. OK: Encoder SW circuit is OK
2. NG: GO TO 2.
CHECK HARNESS CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect power window sub-switch (rear LH or RH) and power window motor (rear LH or RH).
3. Check continuity between power window sub-switch (rear LH or RH) connector D55 (LH), D75 (RH) terminal 19 and power window motor (rear LH or RH) connector D52 (LH), D72 (RH) terminal 5.
  19 (G/Y) - 5 (G/Y): Continuity should exist.
OK or NG
1. OK: GO TO 3.
2. NG: Repair or replace harness.
  
  Fig 3: Checking Continuity Between Power Window Sub-Switch (Rear LH Or RH) Connector D55 (LH), D75 (RH) Terminal 19 And Power Window Motor (Rear LH Or RH) Connector D52 (LH), D72 (RH) Terminal 5
  Courtesy of NISSAN MOTOR CO., U.S.A.
CHECK ENCODER GROUND
1. Connect power window sub-switch (rear LH or RH) connector.
2. Check continuity between power window motor (rear LH or RH) connector D52 (LH), D72 (RH) terminal 4 and ground.
  4 (W/B) - Ground: Continuity should exist.
OK or NG
1. OK: Replace power window motor (rear LH or RH).
2. NG: GO TO 4.
  
  Fig 4: Checking Continuity Between Power Window Motor (Rear LH Or RH) Connector D52 (LH), D72 (RH) Terminal 4 And Ground
  Courtesy of NISSAN MOTOR CO., U.S.A.
CHECK ENCODER GROUND CIRCUIT
Check continuity between power window motor (rear LH or RH) connector D52 (LH), D72 (RH) terminal 4 and power window sub-switch (rear LH or RH) connector D55 (LH), D75 (RH) terminal 20.

4 (W/B) - 20 (W/B): Continuity should exist.

OK or NG
1. OK: Replace power window sub-switch (rear LH or RH).
2. NG: Repair or replace harness.
  
  Fig 5: Checking Continuity Between Power Window Motor (Rear LH Or RH) Connector D52 (LH), D72 (RH) Terminal 4 And Power Window Sub-Switch (Rear LH Or RH) Connector D55 (LH), D75 (RH) Terminal 20
  Courtesy of NISSAN MOTOR CO., U.S.A.