April 5, 2026: LEMON Manuals is launched! Read the announcement.

Check KEYFOB Battery And Function

WARNING: This page is about a different variant/trim than selected.

CHECK KEYFOB BATTERY
1. Remove keyfob battery. Refer to "Keyfob Battery Replacement ".
2. Measure voltage between battery positive and negative terminals.
  1. Voltage: 2.5V - 3.0V
NOTE: Keyfob does not function if battery is not set correctly.

OK or NG
1. OK: GO TO 2
2. NG: Replace battery.
Fig 1: Measuring Voltage Between Battery Positive And Negative Terminals
Courtesy of NISSAN MOTOR CO., U.S.A.
CHECK KEYFOB FUNCTION
With CONSULT-II

Check keyfob function in "DATA MONITOR" mode with CONSULT-II.

When pushing each button of keyfob, the corresponding monitor item should be turned as follows.

Fig 2: Condition And Monitor Item Reference Data Chart
Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 3: Checking Keyfob Function In "DATA MONITOR" Mode With CONSULT-II
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG
1. OK: Keyfob is OK.
2. NG: Replace keyfob.