Accelerator Pedal Position Sensor
WARNING: This page is about a different variant/trim than selected.
- Reconnect all harness connectors disconnected.
- Turn ignition switch ON.
- Check voltage between ECM terminals 106 (APP sensor 1 signal), 98 (APP sensor 2 signal) and ground under the following conditions.
Courtesy of NISSAN MOTOR CO., U.S.A.
- If NG, replace accelerator pedal assembly and go to next step.
- Perform Accelerator Pedal Released Position Learning .
- Perform Throttle Valve Closed Position Learning .
- Perform Idle Air Volume Learning .