Work Flow
- Check the symptom and customer's requests.
- Understand the system description. Refer to "SYSTEM DESCRIPTION ".
- Perform the preliminary check. Refer to "PRELIMINARY CHECK ".
- Perform the communication diagnosis.
With CONSULT-II, refer to "IVMS COMMUNICATION DIAGNOSIS ".
Without CONSULT-II, refer to "COMMUNICATION DIAGNOSIS ".
Is the communication diagnosis result OK?
If OK, GO TO 7.
If NG, GO TO 5.
- Repair or replace depending on the diagnosis result.
- Perform the communication diagnosis again.
With CONSULT-II, refer to "IVMS COMMUNICATION INSPECTION. ".
Without CONSULT-II, refer to "COMMUNICATION DIAGNOSIS ".
Is the communication diagnosis result OK?
If OK, GO TO 7.
If NG, GO TO 5.
- Perform the self-diagnosis.
With CONSULT-II, refer to "SELF-DIAGNOSIS RESULTS ".
Without CONSULT-II, refer to "CANCEL OF SWITCH MONITOR ".
Is the self-diagnosis result OK?
If OK, GO TO 11.
If NG, GO TO 8.
- Repair or replace depending on the self-diagnosis result.
- Perform the self-diagnosis again.
With CONSULT-II, refer to "SELF-DIAGNOSIS RESULTS ".
Without CONSULT-II, refer to "ON BOARD DIAGNOSIS FOR AUTOMATIC DRIVE POSITIONER ".
Is the self-diagnosis result OK?
If OK, GO TO 11.
If NG, GO TO 8.
- Based on the trouble diagnosis chart, repair or replace the cause of the malfunction. Refer to "SYMPTOM CHART ".
- Does the automatic drive positioned system operate normally?
If it is normal, GO TO 12.
If it is not normal, GO TO 4.
- Inspection end.