Read Configuration Procedure

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carries out CAN communication.

With ignition switch OFF, connect CONSULT-II and CONSULT-II CONVERTER to data link connector and turn ignition switch ON.

Fig 1: Connecting CONSULT-II And CONSULT-II CONVERTER To Data Link Connector
Touch "START (NISSAN BASED VHCL)".

Fig 2: CONSULT-II Screen Display - START (NISSAN BASED VHCL)
Touch "BCM" on "SELECT SYSTEM" screen.
If "BCM" is not indicated, go to "CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT ".

Fig 3: CONSULT-II Function Screen Display - Select System
Touch "BCM" on "SELECT TEST ITEM" screen.

Fig 4: CONSULT-II Screen Display - SELECT TEST ITEM
Touch "CONFIGURATION" on "SELECT DIAG MODE" screen.

Fig 5: CONSULT-II Screen Display - SELECT DIAG MODE
Touch "JA60" and "OK" on "VEHICLE SELECT" screen. For canceling, touch "CANCEL" on "VEHICLE SELECT" screen.
NOTE: Confirm vehicle model. Refer to "MODEL VARIATION " in GI section.

Fig 6: CONSULT-II Screen Display - SELECT DIAG MODE
Touch "READ CONFIGURATION" on "SELECT CONFIG ITEM" screen.

Fig 7: CONSULT-II Screen Display - SELECT CONFIG ITEM
Configuration of current BCM is printed out automatically. A listing of manual setting items and auto setting items will be displayed. Auto setting items are preset and cannot be changed. Manual setting items can be set by using WRITE CONFIGURATION PROCEDURE. Refer to "WRITE CONFIGURATION PROCEDURE ".

Fig 8: CONSULT II NISSAN READ CONFIGURATION Screen
Touch "BACK" on "READ CONFIGURATION" screen.

Fig 9: CONSULT-II Screen Display - READ CONFIGURATION