Component Function Check

1. Turn ignition switch ON.
2. Select "LIFT FR SW-UP", "LIFT FR SW-DN" in "Data monitor" mode with CONSULT-III.
3. Check lifting switch (front) signal under the following conditions.
   MONITOR ITEM CONDITION CHART
   
   

   Monitor item	Condition		Status
   LIFT FR SW-UP	Lifting switch front (up)	Operate	ON
   		Release	OFF
   LIFT FR SW-DN	Lifting switch front (down)	Operate	ON
   		Release	OFF

Is the indication normal? 

YES: INSPECTION END

NO: Perform diagnosis procedure. Refer to "DIAGNOSIS PROCEDURE ".