System Initialization

Initialize the system if any of the following work has been done.

Electric power supply to power window switch or motor is interrupted by blown fuse or disconnecting battery cable, etc.
Removal and installation of the regulator assembly.
Removal and installation of the motor from the regulator assembly.
Removal and installation of the harness connector of the power window switch.
Removal and installation of the door glass.
Removal and installation of the front door glass run.
Disconnection and connection of the minus terminal of battery.

Initialization

Follow the steps below after installing each component to the vehicle.

Disconnect the minus terminal of battery or disconnect power window switch harness connector temporarily. Then reconnect after at least 1 minute.
Turn ignition switch ON.
Operate power window switch to make over a half of the window open area.
Draw fully the power window switch in the up direction (auto close position) and hold. Continue holding the switch even when window is completely closed and then release after more than 2 seconds.
Inspect the anti-pinch system function.

NOTE: Initialization may be cancelled with continuous opening and closing operation. In this case, initialize the system.