LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2008 >> EX35 Base, AWD >> Repair and Diagnosis >> Electrical >> Body Electrical >> Power Control System >> Power Distribution System >> Component Diagnosis >> Push-Button Ignition Switch >> Diagnosis Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis Procedure

  1. CHECK PUSH-BUTTON IGNITION SWITCH OPERATION 

    Press push-button ignition switch and check if it turns to ON.

    Does ignition switch turn to ON? 

    YES: GO TO  2.

    NO: GO TO  4.

  2. CHECK IGNITION SWITCH OUTPUT SIGNAL (IPDM E/R) 
    1. Disconnect push-button ignition switch connector.
    2. Check voltage between IPDM E/R harness connector and ground.
      TERMINALS VOLTAGE REFERENCE

      (+) (-) Voltage (V) (Approx.)
      IPDM E/R
      Connector Terminal
      E5 28 Ground Battery voltage

    Is the inspection result normal? 

    YES: GO TO  3.

    NO: Replace IPDM E/R. Refer to REMOVAL AND INSTALLATION  .

  3. CHECK PUSH-BUTTON IGNITION SWITCH CIRCUIT (IPDM E/R) 
    1. Disconnect IPDM E/R connector and BCM connector.
    2. Check continuity between IPDM E/R harness connector and push-button ignition switch harness connector.
      TERMINALS CONTINUITY REFERENCE

      IPDM E/R Push-button ignition switch Continuity
      Connector Terminal Connector Terminal
      E5 28 M50 4 Existed
    3. Check continuity between IPDM E/R harness connector and ground.
      TERMINALS CONTINUITY REFERENCE

      IPDM E/R Ground Continuity
      Connector Terminal
      E5 28 Not existed

    Is the inspection result normal? 

    YES: GO TO  6.

    NO: Repair or replace harness or connector.

  4. CHECK IGNITION SWITCH OUTPUT SIGNAL (BCM) 
    1. Disconnect push-button ignition switch connector.
    2. Check voltage between BCM harness connector and ground.
      TERMINALS VOLTAGE REFERENCE

      (+) (-) Voltage (V) (Approx.)
      BCM
      Connector Terminal
      M122 89 Ground Battery voltage

    Is the inspection result normal? 

    YES: GO TO  5.

    NO: Replace BCM. Refer to REMOVAL AND INSTALLATION  .

  5. CHECK PUSH-BUTTON IGNITION SWITCH CIRCUIT (BCM) 
    1. Disconnect BCM connector and IPDM E/R connector.
    2. Check continuity between BCM harness connector and push-button ignition switch harness connector.
      TERMINALS CONTINUITY REFERENCE

      BCM Push-button ignition switch Continuity
      Connector Terminal Connector Terminal
      M122 89 M50 4 Existed
    3. Check continuity between BCM harness connector and ground.
      TERMINALS CONTINUITY REFERENCE

      BCM Ground Continuity
      Connector Terminal
      M122 89 Not existed

    Is the inspection result normal? 

    YES: GO TO  6.

    NO: Repair or replace harness or connector.

  6. CHECK INTERMITTENT INCIDENT 

    Refer to INTERMITTENT INCIDENT .

    INSPECTION END

scientia non olet · About LEMON Manuals