DTC Confirmation Procedure
- PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
GO TO 2.
- PERFORM DTC CONFIRMATION PROCEDURE
- Turn ignition switch ON and wait at least 1 second.
- Start engine and let it idle for 1 second.
- Turn ignition switch OFF, wait at least 10 seconds, and then turn ON.
- Repeat steps 2 and 3 for four times.
- Check 1st trip DTC.
Is 1st trip DTC detected?
YES: Go to "DIAGNOSIS PROCEDURE ".
NO: INSPECTION END