EXHAUST VALVE TIMING CONTROL LEARNING : Special Repair Requirement

With CONSULT-III 

1. Start engine and warm it up to normal operating temperature.
2. Set selector lever to N position and confirm that following electrical or mechanical loads are not applied.
   • Headlamp switch is OFF
   • Air conditioner switch is OFF
   • Rear defogger switch is OFF
   • Steering wheel is in the straight-ahead position, etc.
3. Keep the engine speed between 1, 800 and 2, 000 rpm.
4. Select "EXH V/T CONTROL LEARN" in "WORK SUPPORT" mode with CONSULT-III.
5. Touch "START" and wait 20 seconds.
6. Check that "CMPLT" is displayed on CONSULT-III screen.

   Learning completed : CMPLT 

   Learning not yet : YET 

Without CONSULT-III 

1. Start engine and warm it up to normal operating temperature.
2. Set selector lever to N position and confirm that following electrical or mechanical loads are not applied.
   • Headlamp switch is OFF
   • Air conditioner switch is OFF
   • Rear defogger switch is OFF
   • Steering wheel is in the straight-ahead position, etc.
3. Keep the engine speed between 1, 800 and 2, 000 rpm at 20 seconds.

   END