Diagnosis Procedure

1. CHECK PUSH-BUTTON IGNITION SWITCH INPUT SIGNAL
   1. Turn ignition switch OFF.
   2. Disconnect push-button ignition switch connector.
   3. Check voltage between push-button ignition switch harness connector and ground.
   VOLTAGE CHART
   
   

   (+)		(-)	Voltage (V) (Approx.)
   Push-button ignition switch
   Connector	Terminal
   M50	4	Ground	Battery voltage

   Is the inspection normal? 

   YES: GO TO  2.

   NO: GO TO  4.

2. CHECK PUSH-BUTTON IGNITION SWITCH

   Refer to "COMPONENT INSPECTION ".

   Is the inspection normal? 

   YES: GO TO  3.

   NO: Replace push-button ignition switch. Refer to "REMOVAL AND INSTALLATION ".

3. CHECK INTERMITTENT INCIDENT

   Refer to INTERMITTENT INCIDENT .

   INSPECTION END

4. CHECK PUSH-BUTTON IGNITION SWITCH CIRCUIT FOR SHORT

1. Disconnect BCM connector M122 and IPDM E/R connector E5.
2. Check continuity between push-button ignition switch harness connector and ground.

Is the inspection normal? 

YES: Replace BCM. Refer to REMOVAL AND INSTALLATION .

NO: Repair harness or connector.