LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2008 >> G35 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 (Engine Control System - Component Testing) >> On-Vehicle Repair >> Intake Valve Timing Control >> Camshaft Position Sensor (PHASE) >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Camshaft Position Sensor (PHASE): Removal

WARNING: This page is about a different car, the 2008 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove engine room cover using power tool. Refer to "REMOVAL AND INSTALLATION ".
  2. Remove air duct and resonator assembly. Refer to "REMOVAL AND INSTALLATION ".
  3. Disconnect camshaft position sensor connector.
  4. Remove camshaft position sensor (2) from Intake valve timing control solenoid valve cover (LH) (1).
    Fig 1: Identifying Camshaft Position Sensor (Phase) Remove/Install Components
    G05378614Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals