April 5, 2026: LEMON Manuals is launched! Read the announcement.

Active Test Mode

Description

Use this mode to determine and identify the details of a malfunction based on self-diagnostic results or data monitor. AWD control unit gives drive signal to actuator with receiving command from CONSULT-III to check operation of actuator.

Test Item

ACTIVE TEST MODE CHART

Test item	Condition	Description
ETS S/V (Detects AWD solenoid)	Vehicle stopped Engine running No DTC detected	Change command current value to AWD solenoid, and then change driving mode. (Monitor value is normal if it is within approximately ± 10% of command value.) Qu: Increase current value in increments of 0.20 A Qd: Decrease current value in increments of 0.20 A UP: Increase current value in increments of 0.02 A DOWN: Decrease current value in increments of 0.02 A

CAUTION: Never continuously energize for a long time.